Welcome Back Readers, Thanks for dropping in for the next installment of the titan build. Here I start the arms, I have already glued and dried the Upper Arm Pistons to the Upper Arm. Next, the Elbows are glued and clamped to the Upper Arm assemblies.
Once dry, the next day I can Arm assemblies into the Shoulder Joints, after roughing up the surface to maximise the surface area for the JB Weld to affix to. There will be a lot of weight pulling this join apart with the weight of the Titan Arm Weapons below it.
Here is a shot of the pin going in place, through the Shoulder Joint and into the Upper Arm. The whole Arm will be further pinned from a pin reaching through the entire assembly from the Shoulder Mounts, through the Shoulders themselves and in through the Shoulder Joints and into the Upper Arms. I am planning on magnetizing the weapons in place using a magnet up in the lower arm coupling and in the top cog of each weapon - yet to purchase the Arm Weapons.
